Plastic Shuttering Ply

Plastic Shuttering:- NEW ERA FOR CONSTRUCTION SECTOR

Considering the labour problem & cost of formwork system we at Desire Construction Systems thought to develop an alternative formwork system which could help the industry to not only reduce construction cost but also a system that is easy to install, dismantle & handle. First time in India a plastic formwork which can over most of the issues discussed above.

The system has following Advantages:

Cost Effective

 Labour Friendly

Eco Friendly

Low in Maintenance

Versatile

Speedy in Installation & Dismantle

Good Quality RCC Finish is Produce

 BRIEF

– This system gives more than 100 repetitions; hence running cost is low. The final RCC work will get smooth finish with minor joint line which does not require plaster. Once you can do putty & paint so you don’t need to plaster and hence it is cost effective.
– This Shuttering Ply is made from special grade plastic and hence no chemical reaction take place nor the material stick to it, Because of this property you cannot get any patched on the RCC finish. Also the gap between two plates are negligible so that no water and cement gets leaked out at the time of RCC & it gets curing from the bottom of the plate also, which enhance the final quality of RCC casting .
– Comparatively our foam systems are very less in weight compare to conventional M.S. Plate (1/4th ) and Plywood (1/2). Hence it is very easy to install, dismantle, transport from one place to another. Due to easy plugging systems & east to fit makes this foam shuttering systems most labour friendly.
– By using Desire systems no need to apply oil to the plates before casting RCC , Due to auto leveling of plugging systems plates are automatically leveled. Hence 30 % time is saves in assembling & also while dismantling the same.
– All existing traditional scaffolding systems can be use in Desire shuttering systems comfortably. You can cast Slab, Beam & Column, etc. A lot of the parts in the Desire system are supportive to each other and you can simply adjusting the locking systems.
– Desire formwork systems is made from Petroleum waste and it’s long lasting and gives more than 100 repetitions. Its replace plywood’s which consumes trees and M.S. which consumes iron ore from our planet earth. Our products help in preventing this precious metal from our earth.
– After every usage of Desire foam systems once can easily clean the plates by water. Where as in M.S. plate one have to apply oil to clean the M.S. surface plates. In Desire plates if any breakage occurs by mishandling it can be very easily sealed by low voltage hot air gun.

COMPARISON :

ITEM Plastic Formwork Traditional Formwork Steel Formwork
Recycled 40% No 10%
Water Resistant Yes No No
Deformation Condition No Yes Yes
Striping Process Easy Moderate Difficult
Size Any Size Can Supply Restricted Restricted
Corrosion Resistant Excellent Bad Bad
Using Time More Then 100 Times 8 to 10 Times 60 to 70 Times
Facebook
Facebook
YOUTUBE
LinkedIn